Keel bands on wooden hulls

Jorge

Keel bands on wooden hulls

Unread post by Jorge »

Hello Classic Finnsters

sorry if this is not the right place for this question but hopefully someone can help.

I am building a wooden Finn model (1:10 scale, that's 45cm long) for display only (not for sailing) and I would like it to look very similar to the earlier Finns. I have never seen a wooden Finn and the pictures I have found are most from the cockpit or from the upper side of the hull. I am trying to find out how the keel bands (is the right name?) are attached to the hull. If I am not wrong, old Finns had one keel band from the bow up to the centerboard trunk, then two at the sides of the CB trunk and finally one from the rear part of the CB trunk up to the transom. Is this correct ? Another question is what material was used for these keel bands (alu ?). Does anybody have a picture of a wooden hull where I can see these details ?

Thanks for any help you can provide.

Best regards

Jorge
Argentina

User avatar
GER 110
Posts: 1976
Joined: 15. September 2005 16:38
Your Boat and Sail-Number: G
Location: Porta Westfalica

Re: Keel bands on wooden hulls

Unread post by GER 110 »

Hello Jorge,

i have some pictures of the keel bands from a Raudaschl-Finn (Austria) build in 1970.
IMG_3338z.jpg
IMG_3339z.jpg
IMG_3340z.jpg
IMG_3340-2z.jpg
IMG_3341z.jpg
The Material was Brass or Alu.

Please send us some pics when you have your model finished.

Best wishes to Argentina

Uwe

User avatar
GER 110
Posts: 1976
Joined: 15. September 2005 16:38
Your Boat and Sail-Number: G
Location: Porta Westfalica

Re: Keel bands on wooden hulls

Unread post by GER 110 »

keel- bands1.jpg
keel- bands1.jpg (54.08 KiB) Viewed 4330 times

Guest

Re: Keel bands on wooden hulls

Unread post by Guest »

Danke schön Uwe, this is very helpful information. In fact, your Finn has exactly the same keel bands that my Finn had when I bought it (is a plastic one, built in the late 70's) but I thought they were different in the wooden Finns. Now the hard part is to find out how to build them in scale for my model...

Sure, I'll send pictures of this model. If you like, I have some pictures of other wooden Finn models (complete and half hulls) that I have built before but I don't know how to post them here. Should I send them by email so you can post them ?

By the way, your wooden hull looks great, congratulations. And the name sounds great too....:)

Best wishes

Jorge

User avatar
GER 110
Posts: 1976
Joined: 15. September 2005 16:38
Your Boat and Sail-Number: G
Location: Porta Westfalica

Re: Keel bands on wooden hulls

Unread post by GER 110 »

Hello Jorge,

if you want, you can send pictures to neumann1@online.de

In the RG65-Forum I found some other Pics. http://www.rg65.de/forum/board_entry.php?id=1203

Do you already know Jan Kingma ? http://www.halfmodellen.nl/Engels-Finn.htm

http://www.halfmodellen.nl/Engels-intro.htm

Best regards

Uwe

Post Reply